Setting up the Unitech TS100 Barcode Scanner
If you've purchased the Unitech TS-100 from our web store and are plugging it into a Star Printer, you may wish to customise the settings for use with Platopus Retail.
After this you can scan the following barcodes, one by one, to set it up for Platopus Printers/Displays/Kitchen:
These should give you the basic settings you need. If you wish to adjust further, the codes to change to other settings can be found in the manual which should be in the box with the scanner.
The manual is also available here:
Related Articles
Setting up your Star MC Printer for Platopus Retail
Overview Setting up your Star MC series Printer is straightforward, but there are a few steps to complete. Plug in in the printer and connect it to the network Connect to the printer using a phone Register the printer with Platopus Retail Assign the ...Setting up a Video Wall
Configure the displays Select the display - click 'view' button Select 'Details' and 'Wall Led Matrix' in the navigation bar. Click 'Edit' Click the 'Configuration' dropdown and select the format that matches the display install configuration. Click ...Star TSP100IV SK hold print sensor
The hold print sensor detects whether the printed label is removed from the paper exit of the printer. When the hold print sensor is enabled, printing of the next label will not start until the printed label is removed. The next label printing is ...Star TSP100IV SK Paper Setup
1. Turn the power on Set paper with the power turned on to automatically feed and cue the paper. 2. Open the printer cover Push the opening lever to open the printer cover . Note When replacing paper, remove the paper core remaining in the paper roll ...Invoicing
Navigate to the 'Catering' section - click the square icon on the top right of the page and select 'Catering' On the 'Catering' page select 'Settings' and 'Invoice' in the navigation. On the 'Invoice Settings' page click 'Edit Settings' On 'Edit ...