Star TSP100IV SK hold print sensor

Star TSP100IV SK hold print sensor

The hold print sensor detects whether the printed label is removed from the paper exit of the printer.

When the hold print sensor is enabled, printing of the next label will not start until the printed label is removed.
The next label printing is possible after the printed label is removed.


This function is enabled by default.

it can be disabled using the following methods

Using the Star Quick Setup Utility App

Connect to the target printer
 Star Quick Setup Utility and connect to the printer you want to setup.

Set up the hold print sensor function
  • Open [Change Printer Settings] - [Memory Switch Settings].
  • Toggle the settings of “Hold Print Control” and “Hold Print Status” to “Disabled” or “Enabled”.
  • Tap [Apply].

Setting by Printer Operation

Follow the procedure below to operate the printer.

Turn power on
  • Press the power button on the back of the printer.


Open printer cover
  • Push the opening lever  to open the printer cover .
​
Set up the hold print sensor function
  • Press the [FEED] button  until the Power LED (blue) begins flashing , then release it.
The blue Power LED flashes (0.25-second intervals).

  • Repeat “long press (1 second or longer) and then release” of [FEED] button  until only the Error LED*1 (red) is shown flashing. .
    *1) For TSP143UEWB SK, Power/Error LED (red)
  • ​
  • The blue Power LED and red Error LED flash simultaneously (0.25-second intervals).
  • ​
  • ​
  • When the cover is closed, the setting mode for the hold print sensor function is entered.

  • When the [FEED] button  is pressed, the LED display content changes.

    • Related Articles

    • Star TSP100IV SK Paper Jam

      When paper jams occur, do not forcibly pull the paper and use the following steps to remove the jammed paper. 1. Turn the power off Press the power switch on the back of the main unit. 2. Open the printer cover Push the opening lever to open the ...

    • Star TSP100IV SK Cutter Locked

      If the printer cover does not open even when you push the open lever, it is likely that a paper jam has occurred, and locked the cutter. Do not force the printer cover to open or pull on the paper. First turn off the power and then turn the power ...

    • Star TSP100IV SK Paper Setup

      1. Turn the power on Set paper with the power turned on to automatically feed and cue the paper. 2. Open the printer cover Push the opening lever to open the printer cover . Note When replacing paper, remove the paper core remaining in the paper roll ...

    • Setting up your Star MC Printer for Platopus Retail

      Overview Setting up your Star MC series Printer is straightforward, but there are a few steps to complete. Plug in in the printer and connect it to the network Connect to the printer using a phone Register the printer with Platopus Retail Assign the ...

    • Setting up the Unitech TS100 Barcode Scanner

      If you've purchased the Unitech TS-100 from our web store and are plugging it into a Star Printer, you may wish to customise the settings for use with Platopus Retail. Unpack the scanner and plug it into the printer, it should beep and illuminate. ...